Power Star 4kva 48v (4000w) Hybrid Pure Sine Wave Inverter with Inbuilt Solar Charger Controller


An inverter take DC (battery) power and converts it over to AC (house outlet) power. 3000 watts is enough to run many regular household items at the same time. Many electrical devices, such as cell phones, laptops, tablet, etc. are considered sensitive electronics and do best on a pure sine wave electrical signal. Pure sign wave is also called a true sign wave or a clean signal. Anything with a battery and most HDTV’s and microwaves need a clean signal to operate properly.

Solar arrays 600 watts or larger benefit from  (PWM) solar charge controller.

3000 Watt pure sine wave inverter / charger with built in 60 amp PWM solar charge controller and the ability to use AC power, shore power or generator power, to charge batteries

60 Amp Pwm Solar Controller built in

(EP3000) HV Model
1012E 1024E 2012E 2024E 3024E 4048E 5048E 6048E
Line Mode Specifications:
Input Voltage Waveform Sinusoidal (utility or generator)
Nominal Input Voltage 230Vac(120VAC selectable)
Low Line Disconnect 184Vac±4%
Low Line Re-connect 194Vac ±4%
High Line Disconnect 265Vac±4%
High Line Re-connect 255Vac±4%
Max AC Input Voltage 270Vrms
Nominal Input Frequency 50Hz/ 60Hz  (Auto detection)
Low Line Frequency Re-connect 58+0.3Hz for 60Hz;48+0.3Hz for 50Hz;
Low Line Frequency Disconnect 57+0.3Hz for 60Hz;47+0.3Hz for 50Hz;
High Line Frequency Re-connect 64+0.3Hz for 60Hz;54+0.3Hz for 50Hz;
High Line Frequency Disconnect 65+0.3Hz for 60Hz;55+0.3Hz for 50Hz;
Output Voltage Waveform As same as Input Waveform
Over-Load Protection(SMPSload) Circuit breaker
Output Short Circuit Protection Circuit breaker
Efficiency (Line Mode) >95%
Transfer Switch Rating 30A
Transfer Time (Ac to Dc) 10ms (typical)
Transfer Time (Dc to Ac) 10ms (typical)
Pass through without Battery Yes
Max Bypass Overload Current 30A
Invert Mode Specifications:
Output Voltage Waveform Sine wave
Rated Output Power (VA) 1000 2000 3000 4000 5000 6000
Rated Output Power (W) 1000 2000 3000 4000 5000 6000
Power Factor 0~1.0
Nominal Output Voltage (V) 230Vac
Nominal Output Frequency (Hz) 50Hz ± 0.3Hz
Auto tracking Main Frequency(Hz) Yes (Following Main first connection)50Hz @48-54Hz ;60Hz @58-64Hz
Output Voltage Regulation ±10% rms
Nominal Efficiency >80%
Over-Load Protection
(SMPS load)
(110%<load<125%) 15=”” :=”” after=”” fault=”” load=”” shutdown=””>150% ±10%:  Fault (shutdown output) after 20s;
Surge rating (10s) 3000VA 6000VA 9000VA 12000VA 15000 VA 18000VA
Capable of starting electric motor 1 HP 1 HP 2 HP 3 HP
Output Short Circuit Protection Current limit (Fault after 10s)
Bypass Breaker Size 30A 30A 30A 35A 50A
Nominal DC Input Voltage 12V 24V 12V 24V 24V 48V 48V
Min DC start voltage 10V/20V/40V
Low Battery Alarm 10.5Vdc ± 0.3Vdc for 12V battery;21.0Vdc ± 0.6Vdc for 24V battery;42.0Vdc ± 0.6Vdc for 48V battery
Low DC input Shut-down 10.0Vdc ± 0.3Vdc for 12V battery;20.0vdc± 0.6Vdc for 24V battery;40.0Vdc± 0.6Vdc for 48V battery
High DC input Alarm & Fault 16Vdc ± 0.3Vdc for 12V battery;32Vdc ± 0.6Vdc for 24V battery; 64Vdc ± 0.6Vdc for 48V battery
High DC input Recovery 15.5Vdc ± 0.3Vdc for 12V battery;31.0Vdc ± 0.6Vdc for 24V battery; 62.0Vdc ± 0.6Vdc for 48V battery
Power saver Load ≤25W (Enabled on “P/S auto” setting of Remote control)
Charge Mode Specifications:
Nominal Input Voltage 230Vac
Input Voltage Range 196~243Vac
Nominal Output Voltage According to the battery type
Nominal Charge Current 35A 35A 65A 35A 45A 35A 40A 50A
Charge Current Regulation ± 5Adc
Battery initial voltage 0 –15.7 Vdc (can operate with 0V battery)
Charger Short Circuit Protection Circuit breaker
Over Charge Protection Bat. V ≥15.7Vdc/31.4Vdc,beeps 0.5s every 1s & fault after 60s
General Specifications
Safety Certification CE
Safety Certification FCC
Operating Temperature Range 0°C to 40°C
Storage temperature 15°C below zero to 60°C
Operation humidity 5% to 95%
Audible Noise 60dB max
Cooling Forced air, variable speed fan
Size 1012E/1024E/2012E/2024E/2048E/3012E/3024E/3048E:580X315X300MM
View Detail